
How to Position, Align and Level Your Dishwasher
If color of door is to be changed, it should be done at this time prior to installing the dishwasher in the opening. (See pages
14 8 15.
Height of Cabinet Cutout and
Positioning of Leveling Wheels
It is recommended that the dishwasher be installed so
that it is level as possible from front to back. To do this:
Measure the height of the cutout opening. If the
countertop extends lower than the cabinet cutout, this is
the dimension that must be used. The minimum height
is 34%“. As shipped, the unit can be installed in a cutout
that is a minimum of 343/e” high. If the cutout is more
than 3445/e” high or less than 34Yo” high, refer to the chart
below for the position the leveling wheels should be put
in.
5
I
35”
Move the leveling wheels to the proper holes. When using
wheel position 1, the front levelers need not be pre-
adjusted. For wheel position 2 or 3, adjust the front
levelers out 4 full turns. If wheel position 4 or 5 is used,
preadjust the front levelers out 10 full turns.
Moving Dishwasher into Opening
Use caution when moving the appliance to prevent
damage to floor coverings. The weight of the appliance
may cause ripping, scratching or other damage to the
floor. For best results, slide appliance onto cardboard or
masonite before moving to prevent damage.
Now you are ready to move the dishwasher into place
so that it can be aligned with adjoining cabinets. Be sure
“Hose-Tie” is removed at this time (See Figure 1). Move
your dishwasher into the opening and make any
adjustment necessary to:
1. Align the door front of the dishwasher, as close as
possible, with the front of the cabinets. (Top to bottom).
2. Make the space between the dishwasher and the
adjoining cabinets the same on each side and the
same width top to bottom.
Note: The front levelers must set firmly against the floor.
Double check to make sure the leveling wheels are at
the right adjustment and the dishwasher is as level as
possible front to back.
7
Comentarios a estos manuales